Camera: Eufy E210 Outdoor Cam
At the time of writing, there are 4 possible firmwares:
The correct one will depend on the image sensor and camera variant (check the underside the camera). There is no way to know without trying each one of these. Once you've configure the camera, if the stream doesn't work, and/or the logs show some sensor error, that means you picked the wrong firmware. Just try another one.
For further instructions, follow the Eufy E220 guide.
- SoC: Ingenic T31X
- Image Sensor: SC3335 or SC3338
- Wi-Fi Module: SYN4343 (SDIO)
- Flash Chip: NOR 32MB
- Power: 5V DC USB
| Type | Details |
|---|---|
| Status LED | Blue / Red |
| White LEDs | 2x White LEDs |
| IR LEDs | 850nm x4 |
Unusual hardware design for LED control:
| Mode | GPIO 6 | GPIO 7 | GPIO 59 | GPIO 60 |
|---|---|---|---|---|
| White LED ON | HIGH | LOW | HIGH | HIGH |
| White LED OFF | LOW | LOW | LOW | LOW |
| IR LED ON | HIGH | HIGH | LOW | HIGH |
| IR LED OFF | LOW | LOW | LOW | LOW |
| Both LEDs ON | HIGH | HIGH | HIGH | HIGH |
| Both LEDs OFF | LOW | LOW | LOW | LOW |
graph TD
PS1[24V Power Supply - White LED] --> GPIO6[GPIO 6 - Global Enable]
PS2[8V Power Supply - IR LED] --> GPIO6
GPIO6 --> GPIO7[GPIO 7 - Mode Selector]
GPIO6 --> GPIO59[GPIO 59 - White LED Control]
GPIO7 --> GPIO60[GPIO 60 - Shared Driver]
GPIO59 --> WhiteLED[White LED]
GPIO60 --> WhiteLED
GPIO60 --> IRLED[IR LED]