Skip to content

Link to pslab-firmware release page #9

New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Merged
bessman merged 1 commit into from
Jan 30, 2025
Merged

Link to pslab-firmware release page #9

Changes from all commits
Commits
Show all changes
1 commit
Select commit
File filter

Filter by extension

Filter by extension
Conversations
Failed to load comments.
Loading
Jump to
Jump to file
Failed to load files.
Loading
Diff view
Diff view
6 changes: 4 additions & 2 deletions README.md
View file
Open in desktop
Original file line number Diff line number Diff line change
Expand Up @@ -123,12 +123,14 @@ This indicates that the firmware has been flashed successfully to the ESP-01 chi
## Preparing the PSLab board
With the firmware successfully flashed onto the ESP-01 chip, the next step is to flash the appropriate firmware onto the PSLab board to enable communication over the UART2 bus.

The firmware for the board is available [here](https://github.com/bessman/pslab-firmware/tree/hack/uart2).
Use the 'pslab-firmware_v6_esp01.hex' image available from the firmware [release page](https://github.com/fossasia/pslab-firmware/releases/latest).

You can follow the same steps as indicated in the [firmware repository](https://github.com/fossasia/pslab-firmware) to flash firmware to the PSLab board.
Follow the steps as indicated in the [firmware repository](https://github.com/fossasia/pslab-firmware?tab=readme-ov-file#flashing) to flash firmware to the PSLab board.

After flashing the firmware to the board, plug in the ESP-01 chip to the header on the board and you are good to go !

> [!NOTE]
> After flashing this firmware to the PSLab, it will no longer communicate over the USB port. To restore the ability to communicate with the PSLab over USB, flash the 'pslab-firmware_v6.hex' image instead (the PSLab always communicates over USB while in bootloader mode, regardless of which application firmware is loaded).

## Building without Arduino IDE

Expand Down